Subject · Metallurgical engineering
Metallurgiyada analitik nəzarət və metrologiyaCLO↔PLO matrix
CLO ↔ PLO matching table
How this subject's course outcomes map onto the programme's learning outcomes.
| Course outcome | PLO 1 | PLO 2 | PLO 3 | PLO 4 | PLO 5 | PLO 6 | PLO 7 |
|---|---|---|---|---|---|---|---|
| CLO 1CLO-10686This subject teaches students standardized control mechanisms for the quality of raw materials, intermediate products and finished alloys at all stages of metallurgical production. students will master the high precision measurement of major components and trace impurities in metals using spectroscopic (eg oes), chromatographic and chemical analysis techniques. also, the processes of calculating measurement errors, calibrating metric systems, and verifying the compliance of test results with international standards will be analyzed. at the end of the course, students will acquire the ability to freely apply quality management systems and perform metrological procedures in production enterprises. | matches | does not match | does not match | does not match | matches | does not match | matches |
Programme learning outcomes
PLO 1
To acquire fundamental knowledge in the field of mathematics, physics, chemistry and mechanics and to acquire the ability to apply them in solving metallurgical engineering problems.
Supported by: CLO 1
PLO 2
To master the raw materials used in metallurgy and their primary processing, methods of obtaining ferroalloys, cast iron and steel production.
No contribution from this subject
PLO 3
To teach production technologies of non-ferrous metals, special smelting devices, working principles and operating characteristics of metallurgical furnaces.
No contribution from this subject
PLO 4
To master the technologies of steel melting in electrometallurgy, induction and electric-arc furnaces, as well as the working principles of modern melting equipment.
No contribution from this subject
PLO 5
To instill the ability to use modern information technologies (solidworks, solidcam, ansys, 3dmax, etc.) in the management of design, research and production processes.
Supported by: CLO 1
PLO 6
Recycling and use of materials, mastering the technologies of obtaining materials by abrasive metallurgy methods.
No contribution from this subject
PLO 7
Forming an approach based on social and environmental responsibility, compliance with labor safety rules, as well as civic awareness and ethical values in professional activity.
Supported by: CLO 1