Subject · Metallurgical engineering
Əlvan metalların metalşünaslığı və termiki emalıCLO↔PLO matrix
CLO ↔ PLO matching table
How this subject's course outcomes map onto the programme's learning outcomes.
| Course outcome | PLO 1 | PLO 2 | PLO 3 | PLO 4 | PLO 5 | PLO 6 | PLO 7 |
|---|---|---|---|---|---|---|---|
| CLO 1CLO-92382The student learns to analyze the physico-chemical properties of non-ferrous metals and their alloys, as well as crystal lattice structures. at the end of the subject, the student acquires the ability to read various phase diagrams and predict the structural changes of alloys. understands the mechanisms of influence of thermal processing processes (hardening, aging, annealing) on the mechanical properties of non-ferrous alloys. the student classifies industrially important alloys (al, cu, ti, mg, ni) and justifies their application in specific fields. in the end, the student is able to determine the defects that occur during the processing of metals and choose the optimal processing modes to eliminate them. | does not match | does not match | matches | does not match | does not match | does not match | does not match |
Programme learning outcomes
PLO 1
To acquire fundamental knowledge in the field of mathematics, physics, chemistry and mechanics and to acquire the ability to apply them in solving metallurgical engineering problems.
No contribution from this subject
PLO 2
To master the raw materials used in metallurgy and their primary processing, methods of obtaining ferroalloys, cast iron and steel production.
No contribution from this subject
PLO 3
To teach production technologies of non-ferrous metals, special smelting devices, working principles and operating characteristics of metallurgical furnaces.
Supported by: CLO 1
PLO 4
To master the technologies of steel melting in electrometallurgy, induction and electric-arc furnaces, as well as the working principles of modern melting equipment.
No contribution from this subject
PLO 5
To instill the ability to use modern information technologies (solidworks, solidcam, ansys, 3dmax, etc.) in the management of design, research and production processes.
No contribution from this subject
PLO 6
Recycling and use of materials, mastering the technologies of obtaining materials by abrasive metallurgy methods.
No contribution from this subject
PLO 7
Forming an approach based on social and environmental responsibility, compliance with labor safety rules, as well as civic awareness and ethical values in professional activity.
No contribution from this subject